For Sale: 1970 Chevrolet Pickup in Bismarck, North Dakota for sale in Bismarck, ND
Vehicle Description 1970 C10 This beautiful C10 is a timeless classic that has been brought back to life and it is breathtaking! Thepaint that was laid out looks beautiful at any angle as pictures will showthe clear adds a TON of depth!All of the panels are nice, straight and the contours are super smooth! This is not such an easy task on big long bedsides, but if you look down theseyou WILL be pleased.
The paint is a base/clear finish with a thoroughly sanded and buffed finish.
It's show quality and is free from the orange peel that plagues new cars.
During the restoration, the frame was media blasted, powder coated and the undercarriage was restored to the same quality as the top of the truck.
You could eat dinner off of it, or you could just admire the beauty.
Either way, it's showroom sharp.
There is NO big spots of bondo on this build! All of the panels are SOLID! The bottom of the doors are nice and sharp as well!All of the glass is clear and new! The bumpers shine well and look good being once again.
.
NEW! All trim looks really good as well.
All doors open and close as smooth as can be with no issues in any way.
All panel gaps also line up well.
The restoration was done with attention to detail and looks great! The engine bay is CLEAN and a fresh 468 (1100 miles)rests between the fenders that starts, runs and drives very well! It isbuilt to around 500 HP.
The gas and air are mixed in a hollycarb with fuel delivered by aAeroquip fuel line and Edelbrock in-line fuel filter pulling fuel from aCustom built aluminum fuel celland the motor exhales through a set of coatedheaders.
The exhaust is a polished stainless Magnaflowsystem with a crisp exhaust note.
The motor runs cool and uses aHigh capacity Aluminum 100% TIG welded radiator with dual electric fans!You will also notice aMarch pully set up in the front to run the accessories and Color matched Hose Candy Jackets installed? on coolant hoses.
AMSD Ignition Blaster coilandMSD Dynaforce mini starter have also been added.
The trans is aSM465 4spd (built by inland truck 1100 mile on it) with hydraulic Center force clutch hooked to aNP205 transfer caseall gear direct drive components.
The rear is a 1970 GM Corporate 12 bolt 3:
73 posi? and a dana 40 up front.
Front axle is completely rebuilt with all new seals, bearings, U Joints and machined steering knuckles from Reid Racingalong with all new machined steering arms installed and torqued for the new crossover steering.
The front spindles replaced with machined parts whichallow to run a larger set of front wheel bearings.
From aRemote mounted power steering reservoir,All Braided Power Steering Hoses?, to Custom Tubular crossmember with integrated motor mounts,fully greasable, heavy duty suspension shackle set and EVERYTHING in between.
this thing a a show stopper! All of the brakes and suspension components are NEW, 4 wheel disk breaks Wilwood front and Bear rear, with Wilwood master) and the truck uses a Slyjack Nitro 8000 shock kit, 6 skyjacker lift with all new springs front and rear, no blocks in the back for this bad boy.
?Everything steering in new as well including Crossover steering components, Drop Pitman Arm andTie Rod Ends and2WD steering boxto allow crossover steering to work.
The truck rides on Hostile wheels, and Nittotires.
Out on the road, the truck is easy to drive for all with the power steering and power brakes.
Transmission and Transfer case are reset into the frame with all new polyurethane bushings everywhere! The interior is also nice and CUSTOM!The seat is custom and in great condition and the carpet is clean brand NEW!The gauges have been switched over to an Autometer setup and you'll stay cool in the cabin with ice cold Classic Auto Air System.
complete modern AC and Heater units, including duct work and vents.
The factory stereo has been replaced with a modern Kenwood touch screen unit with Bluetooth capability,All Kicker Amps, Subs, and Speakers with 1800 total Watts-overkill is an understatement.
The dash looks incredible and all door hardware works as it should mounted on custom door panels.
A custom headliner was also added! This classic C10 turns over with a couple pump and a turn of the key 1sttime EVERY TIME! It is ready for a new home today! The suspension hasbrand new bushings throughout, NEW wheels, tires and a recent alignment!This truck turns heads everywhere it goes and will be a great collector's item with almost everthing new right down to Both new headlight buckets! Take a look at ALL of the pictures once again after reading this.
Top to bottom, front to back, inside and out this truck is a SHOW STOPPER! I have pictures of the truck from start to finish.
I was built right here in ND and built RIGHT! If you have any questions please call Bobat701-527-7721 Or email email protected GOT A TRADE WE'RE INTERESTED!! THANKS FOR LOOKING!!.
The paint is a base/clear finish with a thoroughly sanded and buffed finish.
It's show quality and is free from the orange peel that plagues new cars.
During the restoration, the frame was media blasted, powder coated and the undercarriage was restored to the same quality as the top of the truck.
You could eat dinner off of it, or you could just admire the beauty.
Either way, it's showroom sharp.
There is NO big spots of bondo on this build! All of the panels are SOLID! The bottom of the doors are nice and sharp as well!All of the glass is clear and new! The bumpers shine well and look good being once again.
.
NEW! All trim looks really good as well.
All doors open and close as smooth as can be with no issues in any way.
All panel gaps also line up well.
The restoration was done with attention to detail and looks great! The engine bay is CLEAN and a fresh 468 (1100 miles)rests between the fenders that starts, runs and drives very well! It isbuilt to around 500 HP.
The gas and air are mixed in a hollycarb with fuel delivered by aAeroquip fuel line and Edelbrock in-line fuel filter pulling fuel from aCustom built aluminum fuel celland the motor exhales through a set of coatedheaders.
The exhaust is a polished stainless Magnaflowsystem with a crisp exhaust note.
The motor runs cool and uses aHigh capacity Aluminum 100% TIG welded radiator with dual electric fans!You will also notice aMarch pully set up in the front to run the accessories and Color matched Hose Candy Jackets installed? on coolant hoses.
AMSD Ignition Blaster coilandMSD Dynaforce mini starter have also been added.
The trans is aSM465 4spd (built by inland truck 1100 mile on it) with hydraulic Center force clutch hooked to aNP205 transfer caseall gear direct drive components.
The rear is a 1970 GM Corporate 12 bolt 3:
73 posi? and a dana 40 up front.
Front axle is completely rebuilt with all new seals, bearings, U Joints and machined steering knuckles from Reid Racingalong with all new machined steering arms installed and torqued for the new crossover steering.
The front spindles replaced with machined parts whichallow to run a larger set of front wheel bearings.
From aRemote mounted power steering reservoir,All Braided Power Steering Hoses?, to Custom Tubular crossmember with integrated motor mounts,fully greasable, heavy duty suspension shackle set and EVERYTHING in between.
this thing a a show stopper! All of the brakes and suspension components are NEW, 4 wheel disk breaks Wilwood front and Bear rear, with Wilwood master) and the truck uses a Slyjack Nitro 8000 shock kit, 6 skyjacker lift with all new springs front and rear, no blocks in the back for this bad boy.
?Everything steering in new as well including Crossover steering components, Drop Pitman Arm andTie Rod Ends and2WD steering boxto allow crossover steering to work.
The truck rides on Hostile wheels, and Nittotires.
Out on the road, the truck is easy to drive for all with the power steering and power brakes.
Transmission and Transfer case are reset into the frame with all new polyurethane bushings everywhere! The interior is also nice and CUSTOM!The seat is custom and in great condition and the carpet is clean brand NEW!The gauges have been switched over to an Autometer setup and you'll stay cool in the cabin with ice cold Classic Auto Air System.
complete modern AC and Heater units, including duct work and vents.
The factory stereo has been replaced with a modern Kenwood touch screen unit with Bluetooth capability,All Kicker Amps, Subs, and Speakers with 1800 total Watts-overkill is an understatement.
The dash looks incredible and all door hardware works as it should mounted on custom door panels.
A custom headliner was also added! This classic C10 turns over with a couple pump and a turn of the key 1sttime EVERY TIME! It is ready for a new home today! The suspension hasbrand new bushings throughout, NEW wheels, tires and a recent alignment!This truck turns heads everywhere it goes and will be a great collector's item with almost everthing new right down to Both new headlight buckets! Take a look at ALL of the pictures once again after reading this.
Top to bottom, front to back, inside and out this truck is a SHOW STOPPER! I have pictures of the truck from start to finish.
I was built right here in ND and built RIGHT! If you have any questions please call Bobat701-527-7721 Or email email protected GOT A TRADE WE'RE INTERESTED!! THANKS FOR LOOKING!!.
|
|